< Terug naar vorige pagina

Publicatie

Numerical simulations of flow fields through conventionally controlled wind turbines & wind farms

Tijdschriftbijdrage - Tijdschriftartikel Conferentiebijdrage

In the current study, an Actuator-Line Model (ALM) is implemented in our in-house pseudo-spectral LES solver SP-WIND, including a turbine controller. Below rated wind speed, turbines are controlled by a standard-torque-controller aiming at maximum power extraction from the wind. Above rated wind speed, the extracted power is limited by a blade pitch controller which is based on a proportional-integral type control algorithm. This model is used to perform a series of single turbine and wind farm simulations using the NREL 5MW turbine. First of all, we focus on below-rated wind speed, and investigate the effect of the farm layout on the controller calibration curves. These calibration curves are expressed in terms of nondimensional torque and rotational speed, using the mean turbine-disk velocity as reference. We show that this normalization leads to calibration curves that are independent of wind speed, but the calibration curves do depend on the farm layout, in particular for tightly spaced farms. Compared to turbines in a lone-standing set-up, turbines in a farm experience a different wind distribution over the rotor due to the farm boundary-layer interaction. We demonstrate this for fully developed wind-farm boundary layers with aligned turbine arrangements at different spacings (5D, 7D, 9D). Further we also compare calibration curves obtained from full farm simulations with calibration curves that can be obtained at a much lower cost using a minimal flow unit. © Published under licence by IOP Publishing Ltd.
Tijdschrift: Journal of Physics: Conference Series
ISSN: 1742-6588
Issue: 1
Volume: 524
Jaar van publicatie:2014
BOF-keylabel:ja
IOF-keylabel:ja
Authors from:Higher Education
Toegankelijkheid:Open