Experimental analysis of minimum ignition temperature of coal dust layers in oxy-fuel combustion atmospheres

© 2014 Published by Elsevier Ltd. An experimental investigation into the hot surface ignition of coal dust layers has been undertaken in oxy-fuel combustion atmospheres, with the oxygen mole fractions in the range of 21-50 vol. % (21%, 30%, 40% and 50%). Three coals were used to determine the minimum layer ignition temperature (MLIT) with a hot surface ignition apparatus according to the European EN50281-2-1 norm. In addition, thermal and kinetic parameters were also determined. Layer thicknesses of 5, 12.5, 15, 20 and 30mm were investigated. Firstly, 5 and 12.5mm thick coal dust layers were used to investigate the influence of the oxygen mole fraction on the MLIT, and the steady state dust layer temperature profile of a 30mm thick coal dust layer was used to estimate the thermal conductivity (k) at a low hot surface temperature. Secondly, the South African coal was used in this study to determine the kinetic parameters on the basis of the Frank-Kamenetskii theory. Results show that oxygen concentration has a significant influence on the MILT, (i.e., MLIT decreases with increasing oxygen concentration). It also shows that replacing N2 in the combustion air with CO2 a small increase of the MLIT will occur. The estimated k of the coal dust samples is respectively 0.1, 0.11 and 0.1 W·m-1 ·K-1 for South African coal, Sebuku coal and Pittsburgh coal. The region of the kinetic parameters of South African coal changes when there is a shift in the test from air to oxy-fuel combustion atmospheres, which means that the reaction mechanism of self-heating or ignition changed somewhat.

Publication year:2015

BOF-keylabel:yes

IOF-keylabel:yes

Authors from:Private, Higher Education